2024 National Narrow Gauge Convention

Comments

• randyp

  March 11

  Ken, I will be helping in the contest room. I hope you will bring a model to enter. Stop in and say Hi. Also, consider coming to St. Louis next year for the 45th. I will be the contest chair for that one. Randy
• mikemettelka

  March 11

  Too far for me to go this year....
• kebmo

  March 11

  someday....
  
• KKarns

  March 11 edited March 11

  Randy, Nice to hear you’ll be there. I sent the organizational folks an e-mail to see if there would be an area for “display only”. Haven’t heard back. Do you have any idea if there would be space available for display? I don’t have an interest in entering any model contests however, it’s like my Dad, who was into antique cars, use to say “not as much fun going to an old car show without an old car”….
• KKarns

  March 11

  No need to check Randy. I just got word from the convention folks that display only is fine. Still need to enter it in the contest area just with a label for display only.
• MuddyCreekRR

  March 11

  I'll be there on staff working the vendor area.....I am bringing a diorama for the contest though....
• Dave_S

  March 12

  Ken, Randy and Art,
  Please take pictures of the displays, contest entries or jus entries shown for Convention attendee enjoyment and share them with us.
  Later, Dave S. Tucson, AZ
• Karl.A

  March 12

  Unfortunately PA is too much of a drive for me this year.
  St Louis next year is almost a definite for me though...
• KKarns

  March 12

  Nice to hear Art. Look forward to knocking elbows with you guys!
  
  Will do Dave.
  
  I get that Karl. The NNGC has always seemed a bit too far for me in the past. Pittsburg is only 3.5 hrs from me so no brainer! St. Louis sounds doable for 2025...
• randyp

  March 12

  Ken, I just checked the forum and that is usual to have a display area. It is usually on a first come basses. Karl, If you come to St. Louis please bring a model. Art, I am also planning to take a dorama this year. Dave, The first of May the Sn3 Symposium Will be about two hours away from you in Mesa, AZ. Randy
• KKarns

  March 12

  Thanks Randy, I'll make sure I get there as soon as the contest area opens. I'm planning to bring one maybe two dioramas.
• minion

  March 12

  KKarns said:

  Nice to hear Art. Look forward to knocking elbows with you guys!
  
  Will do Dave.
  
  I get that Karl. The NNGC has always seemed a bit too far for me in the past. Pittsburg is only 3.5 hrs from me so no brainer! St. Louis sounds doable for 2025...

  
  Ken ,
  
  St. Louis was doable for me in 2010 and that is just over 4,000 miles away , I’m sure it is doable for you if you put you mind to it !
  
  Nick
• KKarns

  March 12

  Whoa Nick, 4,000!...no worries if you're flying! I'm looking at drive miles. Like my Dad, who collected and restored antique cars, said "not as much fun going to an old car show without an old car"...
• vietnamseabee

  March 13

  I’m waiting again for the show to come back to Hickory which is close for me…. We were just coming out of Covid when the show was at Hickory and I decided against going
  Terry
• TomMich

  March 13

  I'm not going to Pittsburgh, a bit too far, but plan on attending St. Louis.
• kebmo

  March 17

  Karl.A said:

  Unfortunately PA is too much of a drive for me this year.
  St Louis next year is almost a definite for me though...

  that sounds doable for me too.
  
  
  
• MuddyCreekRR

  March 26

  while I totally understand the distance to travel....the ability to see stuff in person....find like minded people and network....and since most brick and mortar hobby shops are gone...these shows are a great place to find stuff...and people sometimes have some very good deals on stuff....the group I belong to The On30 Blacksheep have 4 regular shows...or meets.....2 in Harrisburg Pa. and 2 in Gardiner NY....the Harrisburg shows, the first coming up on April 6th....is technically a 2 Rail O scale....but is heavily On30....the First Mid Hudson Meet in NY is April 20th and 21st, and is more of a 2 day meet to build stuff and sell stuff...very small, but its a great time....the Narrow O show Harrisburg is a huge venue, we have clinics, several module layouts, and a lot of vendors....if you go to the On30 Modelers page on Facebook you can find more info....all I can say is if you can attend any of the National Narrow Guage Conventions....you will agree its almost always worth the extra effort....Hope to see a lot of you there...