I had to elevate the drive shaft on my "#300 Mill Engine" kit build to accommodate my shingle mill and have the shafts line up, maybe you could do something similar (in reverse) to lower your drive li

Started the build in 2010, finally finished 10 years later.

This is my first Sierra West kit build. I joined the forum in late 2013 just in time to purchase the Tool Shed kit #3005 before it sold out. As I understand, it was originally offered as part of the

-I extended the roundhouse to the back to make a "shop" area and will use kit #300 to put a boiler et.al to power the shop